The 2002 ford explorer has 7 problems reported for power door lock not working.
02 explorer no door lock.
Push the power door unlock button once to turn on the auto lock feature.
The horn will chirp once if auto lock was deactivated or twice one short and one long chirp if auto lock was activated.
Average failure mileage is 95 400 miles.
Two beeps one short and one long signals that the auto locks have been enabled so if you receive two beeps start the process over again.
Turn the ignition to off.
2002 ford explorer door ajar problem fixed.
One beep confirms the auto locks have been disabled.
Re upload from my old channel.
No door is opened but the doors refuse to lock and the warning light stays on.
Press the power door unlock control three times.
The horn will chirp.
Press the unlock control then press the lock control.
The common problem is that the switch is not closed this will cause your dome lite to be on door ajar light on and will malfunction any aftermarket auto alarm.
Turn the ignition back to on.
They wont work with the fob or the combination pad outside the door either i need to know where the door lock relays are located and would love to have a door lock wiring diagram i already removed the drivers door panel and the rubber wire duct in the door jamb and found a red wire broken and tada.
The first thing to get keyless entry door factory code you need to locate the passenger fuse panel.
Older versions used a plunger that you could easily test with with your fingers.
My 02 ford explorer power door locks just up and quit all at the same time.
Press the power door lock button once and listen for the horn to beep one time.
Ford explorer since 1995 has been using an in door switch for the door jamb.
Since then when it is hot i get a door open warning light.